MIL-R-46837B (MI)
MIL-STD-1190 Minimum Guidelines for Level C Preservation, Packing and Marking
(Unless otherwise indicated, copies of federal and military specifications, standards, and handbooks are available from the Standardization Documents Order Desk, Bldg 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.)
2.2 Non-Government publications. The following document(s) form a part of this document to the extent specified herein. Unless otherwise specified, the issues of the documents which are DOD adopted are those listed in the issue of the DODISS cited in the solicitation. Unless otherwise specified, the issues of documents not listed in the DODISS are the issues of the documents cited in the solicitation (see 6.2).
UNDERWRITER LABORATORIES, INC. STANDARD: Subject no. 5 for Surface Metal - Raceways and Fittings.
(Application for copies should be addressed to Underwriter Laboratories, Inc., Walt Whitman Road, Melville, Long Island, New York 11749).
(Non-Government standards and other publications are normally available from the organizations that prepare or distribute the documents. These documents also may be available in or through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited herein (except for related associated detail specifications, specification sheets, or MS standards), the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Raceways. Raceways covered by this specification shall conform to the requirements of Underwriter Laboratories, Inc. standard subject no. 5 for surface raceways and fittings.
3.2 Construction. Raceways shall be constructed of mild steel and shall consist of two metal pieces so formed and constructed as to provide a complete and secure enclosure which will afford adequate protection against mechanical injury or rodent destruction of wire conductors.
3.3 Dimensions. Overall dimensions for each type raceway shall be as
specified in tables I, II, III, and IV, and figures 1, 2, 3, and 4. Radii and dimensions for controlling the general shape shall be controlled by the manufacturer's practice.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business