MIL-DTL-24705B(SH)
1.2.1.3 Item material. Item material is as specified (see 3.1) with the item material designated by a single letter
specified as follows:
A = Aluminum
B = Brass
C = Corrosion-resistant steel (CRES)
G = Glass reinforced plastic (GRP)
N = Not specified
S = Steel
Z = Galvanized steel
1.2.1.4 Item designation. Item designation is as specified (see 3.1).
1.2.1.4.1 Cable insert blocks. Cable insert blocks are differentiated by an item designation consisting of the
following format "xxxx/xx(x)". The first two digits indicate the exterior width of the cable insert block in
millimeters (mm). The next two digits indicate the diameter of the passage of the cable insert block in mm. If the
cable passage diameter is fixed, the remaining digits will not be used. If the block has an adjustable cable passage
diameter, the next four digits indicate the minimum and maximum diameters in mm. When an insert block is
designed to accept multiple cables, the number of cables that can be accommodated are enclosed by "( )" at the end
of the item designation.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3, 4, or 5 of this specification. This
section does not include documents cited in other sections of this specification or recommended for additional
information or as examples. While every effort has been made to ensure the completeness of this list, document
users are cautioned that they must meet all specified requirements of documents cited in sections 3, 4, or 5 of this
specification, whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards and handbooks. The following specifications, standards and handbooks form a
part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are
those cited in the solicitation or contract.
FEDERAL SPECIFICATIONS
C-T-91
-
Tallow, Inedible
FEDERAL STANDARDS
FED-STD-H28
-
Screw-Thread Standard for Federal Services
FED-STD-H28/2
-
Screw-Thread Standards for Federal Services Section 2, Unified Inch
Screw Threads-UN and UNR Thread Forms
DEPARTMENT OF DEFENSE SPECIFICATIONS
MIL-S-901
-
Shock Tests, H.I. (High-Impact) Shipboard Machinery, Equipment, and
Systems, Requirements for
MIL-DTL-16884
-
Fuel, Naval Distillate
MIL-PRF-17331
-
Lubricating Oil, Steam Turbine and Gear, Moderate Service
MIL-DTL-24643
-
Cables and Cords, Electric, Low Smoke, for Shipboard Use, General
Specification for
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business